Comments on: Power Steering Pump Rebuild on 2003 – 2007 Accord

By: Piyke

Piyke — Fri, 01 Feb 2019 09:01:33 +0000

In reply to Matt. Thanks a lot. Confirmed. I will proceed to add it as a caveat in the write up. Thanks again!

By: Matt

Matt — Fri, 01 Feb 2019 02:49:43 +0000

Good writeup. But I see one issue. When installing the new bearing on the shaft, you NEVER, EVER, EVER hammer or press on the outer race. This puts LOTS of force on the bearing itself, which can damage it. Instead, use a socket that fits over the inner race, place the end of the shaft on a block of wood, and hammer on the socket while holding it straight. Likewise, hammer or press only on the outer race when installing the bearing in a bore (which WAS done properly here).

By: Piyke

Piyke — Sun, 10 Dec 2017 11:41:12 +0000

In reply to Idorenyin Ukoh.

Hi Udorenyin,

Are you asking for the power steering rebuild kit or the engine rebuild kit?

If it’s the power steering kit try here
https://www.rockauto.com/en/catalog/honda,2003,accord,3.0l+v6,1415630,steering,power+steering+pump+seal+kit,7407
This appears to be for the pump seal. You will have to purchase the bearing separately. Bearing is available on the same site.

By: Idorenyin Ukoh

Idorenyin Ukoh — Thu, 30 Nov 2017 13:49:51 +0000

How does one get the rebuild kit for Honda Accord 2003 V6 3.0 litre engine, also how much does it cost